Epson 3865X Plus - Manual (Page 144)

3. To run the program, press Y; to exit to MS-DOS without
running CORFIX, press
N. If you press Y, you see the
MS-DOS prompt and this message:
Configuration completed. The SMART
installation utility may now be
used.
4. Use the SMART setup program now. See your
RampagePlus 286 manual for instructions.
Post-installation Setup
After you install or remove a math coprocessor or memory
modules, you need to run the Setup program on your Reference
diskette so it can automatically update the computer’s
configuration information. If you install or remove any other
type of option, such as an option card or a disk drive, it is
important to run Setup to check if you need to change any
settings. For example, if you add a hard disk drive, you need to
let the computer know the type of drive you have installed. See
Chapter 2 for instructions.
If you install a hard disk drive that has never received a
hardware level format (such as some non-Epson hard disk
drives), you may need to format the disk. Check the manual
that came with your hard disk drive, and then, if necessary,
follow the instructions in Appendix C to format your new hard
disk.
If you have added a hard disk drive and you want to load
MS-DOS or another operating system from that drive, you need
to install the operating system on it. See your MS-DOS
Installation Guide or the documentation that came with your
operating system for instructions.
5-38 Installing and Removing Options