Epson 3865X Plus - Manual (Page 194)

How to Use This Appendix
Keep in mind that all drives sold by Epson are qualified for use
in Epson computers and are recommended for use in this
system. The instructions in this appendix describe how to install
and remove optional Epson diskette and hard disk drives. Your
drive may look a bit different from the drive illustrated in this
appendix, but you install it the same way. If you received
additional documentation with your Epson drive, follow these
instructions instead of using that documentation.
If you are installing or removing a non-Epson drive, some of the
steps in this appendix may not apply to your drive. If this is the
case, see the documentation that came with your drive for more
information.
Each section in this appendix describes a part of the process you
may need to perform; you do not need to perform all of the
steps. Here are the guidelines:
Before you perform any of the procedures described in this
appendix, follow the steps in Chapter 5 to remove the
computer’s cover.
If you are installing or removing a hard disk drive, follow
the steps under “Setting the Hard Disk Drive Jumpers,” on
page B-4, first. The guidelines at the end of that section tell
you which steps to perform next.
If you are installing or removing a diskette drive and you
currently have a hard disk drive installed in the vertical
mounting position, see “Removing a Hard Disk from the
Vertical Position,” on page B-24. The steps in that section
lead you to any other instructions you need to follow.
If you are installing or removing a diskette drive and you do
not have a hard disk drive installed in the vertical
mounting position, see “Installing or Removing a Disk
Drive in the Horizontal Position,” on page B-27.
Installing and Removing Disk Drives
B-3