Epson 3865X Plus - Manual (Page 199)

Installing a Hard Disk in the Vertical Position
Follow the instructions in this section to install (or reinstall) a
hard disk drive in the vertical mounting position. You may need
to perform the following procedures:
Removing the mounting frames from a new hard disk drive
Removing the mounting plate from the computer and
connecting it to the drive
Installing the drive
Connecting the drive and power cables.
If you are installing a new drive in the vertical mounting
position, you should follow all of the steps in this section. If you
are reinstalling a drive that you previously removed from this
position, see “Installing the Drive,” on page B-13.
Removing the Mounting Frames From the Drive
Your hard disk drive comes with 5 mounting frames
attached to each side of the hard disk drive, as shown below.
B-8
Installing and Removing Disk Drives