Epson 3865X Plus - Manual (Page 100)

Run the AFDD program to reassign the drive. See “Using
the AFDD Program,” below, for instructions.
Your assignments remain in effect until you press the RESET
button or turn off the computer, or until you reassign the drives
to their original assignments. The reassignment remains in
effect if you reset the computer from your hard disk by entering
the
CTRL ALT DEL command.
Using the AFDD Program
The AFDD program reverses the current diskette drive
assignments and resets the system. When you are done using the
reversed drive assignments, you can use the AFDD program
again to reassign the drives to their original configuration.
The AFDD program is provided with your system on the
Reference diskette. If you do not have a hard disk, insert your
Reference diskette into drive A before you enter the command
to start the program. If you have a hard disk drive, copy the file
AFDD.EXE from your Reference diskette onto your hard disk so
you can run the program from there. See Chapter 3 for more
information.
To run the AFDD program, type the following at the MS-DOS
command prompt and press Enter:
AFDD
You see a message such as the following:
Reassign Floppy Drive Utility
New Assign Present
Drive A: 1.44MB <= 1.2MB
Drive B: 1.2MB <= 1.44MB
(S)et and Reboot, Any other key to
abort ?
4-8 Enhancing System Operations