Epson 3865X Plus - Manual (Page 209)

Connecting the Hard Disk Drive Cables
Follow these steps to lift up the subassembly and connect the
drive cable to the main system board:
1. Remove the front panel from the computer by lifting up
slightly on the three clips at the top of the panel and tilting
the panel toward you. Then set it aside.
clips
2. To lift the subassembly from the front of the computer,
place your thumbs under the diskette drive and grasp the
top edge of the computer with the rest of your fingers. (If
you have a diskette drive installed in the lower horizontal
drive bay, place your thumbs underneath that drive
instead.) Then lift up the subassembly with your thumbs.
B-18
Installing and Removing Disk Drives