Epson 3865X Plus User Manual

Page 273

Make sure you save your password setting and that you
highlight

** EXIT AND SAVE **

when you leave

the Setup program.

After you exit Setup, you see this message:

TURN OFF POWER AND CORRECT JUMPER

SETTING TO ENABLE PASSWORD CHECKING

Remove the Reference diskette, turn off the computer, and

follow the instructions under “Changing the Jumper
Settings” in Chapter 5 to enable the password function by
setting jumper J1 to position A.

If you do not have a hard disk, insert the Startup diskette in

drive A. Turn on the computer. You see the key prompt

If you enabled network server mode, you do not see

the key prompt. Enter your new password to access the

system. (See “Using the Power-on Password” in Chapter 3.)

Note

Be sure to remember your new password or write it down and

keep it in a safe place. If you forget the

you enter

now, you may have to repeat the procedure above the next

time you turn on your computer.

D-12 Troubleshooting