ProSoft Technology PTQ-PDPMV1 - Manual (Page 97)

PTQ-PDPMV1 ♦ Quantum Platform Configuring the Processor with Unity Pro
PROFIBUS DP Master Network Interface Module for Quantum User Manual
ProSoft Technology, Inc. Page 97 of 306
August 12, 2014
3.5.8 SetOperatingMode Mailbox
Function Block: SETOPERMODE
Trigger Byte: SetOperate, SetStop, SetClear
Description: The following trigger values can be used to change the current
operating mode of the module:
SETOPERATINGMODE.Out.SelectOperate = Set Operate
SETOPERATINGMODE.Out.SelectStop = Set Stop
SETOPERATINGMODE.Out.SelectClear = Set Clear
3.5.9 SetSlaveMode Mailbox
Function Block: SETSLMODE
Trigger Byte: SetSlaveMode
Description: The SETSLMODE function block can be used to request the
module to sync, unsync, freeze, or unfreeze. The slave address must be selected
through the SlaveAddrIn input pin. If the operation is directed to a group of
slaves, then the group number must be set through the GroupIn input pin
parameter. The actual code that will select the operation type must be configured
through the ControlIn input pin. Please check the slave's user manual for valid
control codes.
Important Note: The next mailbox is only for Anybus firmware version 3.50 and later. Earlier
released versions do not support this feature.