ProSoft Technology PTQ-PDPMV1 - Manual (Page 74)

Configuring the Processor with Unity Pro PTQ-PDPMV1 ♦ Quantum Platform
User Manual PROFIBUS DP Master Network Interface Module for Quantum
Page 74 of 306 ProSoft Technology, Inc.
August 12, 2014
3 As the project is built, Unity Pro reports its process in a Progress dialog box,
with details appearing in a pane at the bottom of the window. If you are using
the sample project, the project should build without errors. The following
illustration shows the build process under way.
3.1.5 Downloading the Project to the Quantum Processor
1 Open the PLC menu and then choose C ONNECT . This action opens a
connection between the Unity Pro software and the processor, using the
address and media type settings you configured in the previous step.
2 On the PLC menu, choose T RANSFER P ROJECT TO PLC. This action opens
the T RANSFER P ROJECT TO PLC dialog box. If you would like the PLC to go to
RUN mode immediately after the transfer is complete, select (check) the PLC
R UN AFTER T RANSFER check box.