Yaskawa VS-626 MC5 - Manual (Page 78)

4.2Modes
- 15
Table 4.3 Constants Monitored in Operation Mode (Continued)
Func-
Con- Name Output Signal Levels for
Min
Valid Access Levels
Func-
tion
Con
stant
No.
Digital Operator
Display
Function
Output Signal Levels for
Multi-function Analog Out-
puts
Min.
Units Open Loop
Vector
Flux
Vector
U2-01
Current fault
Information on the current fault Q Q U2-01
Current Fault
Information on the current fault Q Q
U2-02
Last fault
Information on the last fault Q Q U2-02
Last Fault
Information on the last fault Q Q
U2-03
Frequency refer-
ence at fault
Frequency reference value when
the “last fault” occurred 0.01
Hz
Q Q U2 03
Frequency Ref
the “last fault” occurred. Hz
Q Q
U2-04
Output frequency
at fault
Output frequency when the “last
fault” occurred 0.01
Hz Q Q U2 04
Output Freq
fault” occurred. Hz Q Q
U2-05
Output current at
fault
Output current when the “last
fault” occurred
0.1 A Q Q U2 05
Output Current
fault” occurred. 0.1 A Q Q
U2-06
Motor speed at
fault
Motor speed when the “last
fault” occurred 0.01
Hz Q Q U2 06
Motor Speed
fault” occurred. Hz Q Q
U2-07
Output voltage ref-
erence at fault
Output voltage when the “last
fault” occurred
0.1 V Q Q
Fault
U2 07
Output Voltage
fault” occurred. 0.1 V Q Q
Fault
trace
(See
note )
U2-08
DC bus voltage at
fault
The main circuit DC voltage
when the “last fault” occurred
Can’t be output.
1 V Q Q note.) U2 08
DC Bus Voltage
when the “last fault” occurred. 1 V Q Q
U2-09
Output power at
fault
Output power when the “last
fault” occurred
0.1 kW Q Q U2 09
Output kWatts
fault” occurred.
0.1 kW Q Q
U2-10
Torque reference
at fault Torque reference when the “last
fault” occurred.
0.1 % Q Q U2 10
Torque Reference
au t occu ed.
(The rated torque = 100%.)
0.1 % Q Q
U2-11
Input terminal sta-
tus at fault Input terminal status when the
“last fault” occurred.
Q Q U2 11
Input Term Sts
ast au t occu ed.
(Same format as U1-10.)
Q Q
U2-12
Output terminal
status at fault Output terminal status when the
“last fault” occurred.
Q Q U2 12
Output Term Sts
ast au t occu ed.
(Same format as U1-11.)
Q Q
U2-13
Operation status
at fault Inverter operating status when
the “last fault” occurred.
Q Q U2 13
Inverter status
t e ast au t occu ed.
(Same format as U1-12.)
Q Q
U2-14
Cumulative opera-
tion time at fault
Elapsed operating or power-on
time when the “last fault” oc-
1 hr Q Q U2 14
Elapsed time
time when the last fault oc
curred. 1 hr Q Q
Note When faults CPF00, 01, 02, 03, UV1 and UV2 occur, a fault trace is not performed.
4