Yaskawa VS-626 MC5 - Manual (Page 74)

4.2Modes
- 11
4.2.4 Operation Mode
Operation mode is the mode in which the Inverter can be operated.
Many user constants can’t be changed when the Inverter is operating. Refer to User Constant List for de-
tails.
The following monitor displays are possible in operation mode: The frequency reference, output frequen-
cy, output current, and output voltage, as well as fault information and the fault history.
When running the Inverter, press the MENU Key first to enter the operation mode and then press the DATA/
ENTER Key from the operation mode display to bring up the monitor display.Run commands can’t be re-
ceived from any other display. Once the Inverter is running, it can be switched to other modes.
J Operations in Operation Mode
Key operations in operation mode are shown in Figure 4.6.
All modes/constants
status
MC5 Main Menu
Operation
Output Freq
U1 -- 02 = 0 . 00 Hz
Output Current
U1 -- 03 = 0 . 00 A
Output Voltage
U1 -- 06 = 0 . 0 VAC
Function U2
Fault Trace
Power ON
Frequency Ref
U1 -- 01 = 0 . 00 HZ
Current Fault
None
MENU
ESC
DAT
A ENTER
ESC
DAT
A ENTER
Operation Mode
Output frequency display
Output current display
Output voltage display
Function selection U2 (fault trace)
Frequency reference setting/display
Contents of fault trace
Function U3
Fault History
Function U1
Monitor
Last Fault
None
Frequency Ref
U1 -- 01 = 0 . 00 HZ
ESC
DAT
A ENTER
ESC
DAT
A ENTER
Function selection U3 (fault history)
Function selection U1 (Monitor)
Contents of fault history
Various monitors
Fig
4.6 Operations in Operation Mode
J Conditions for Monitoring
Table 4.3 shows the items that can be monitored in operation mode.
4
IMPORTANT