Yaskawa VS-626 MC5 - Manual (Page 169)

7.3 Common Functions
- 31
7.3.5 External Terminal Functions: H
This section describes the settings for the external terminal functions.
J Multi-function Input Settings: H1
The settings and functions for the multi-function inputs are listed in Table 7.5.
Table
7.5 Multi-function Input Functions
Setting
Control Method
Setting
value Function Open Loop
Vector
Flux vector
0 3-wire sequence (Forward/Reverse run command)
1 Local/Remote selection (ON: Operator, OFF: Constant setting)
2 Option/Inverter selection (ON: Option card)
3
Multi-step speed reference 1
When H3-05 is set to “0,” this function is combined with “Master/auxiliary speed switch.”
4 Multi-step speed reference 2
5 Multi-step speed reference 3
6 Jog frequency reference (higher priority than multi-step speed reference)
7 Accel/Decel time 1
8 External baseblock NO (NO contact: Baseblock at ON)
9 External baseblock NC (NC contact: Baseblock at OFF)
A Accel/Decel ramp hold (ON: Accel/decel stopped, frequency on hold)
B OH2 alarm signal input (ON: OH2 will be displayed)
C Multi-function analog input selection (ON: Enable)
E Speed control integral reset (ON: Integral control disabled)
F Not used. (Do not input this setting.)
10 Up command (Always set with the down command)
11 Down command (Always set with the up command)
12 FJOG command (ON: Forward run at jog frequency d1-09)
13 RJOG command (ON: Reverse run at jog frequency d1-09)
14 Fault reset (Reset when turned ON)
15 Emergency stop (ON: Deceleration to stop in emergency stop time C1-09)
16 Motor switch command (Motor 2 selection)
1A Accel/Decel time 2
1B
Constants write enable (ON: All constants can be written-in. OFF: All constants other than frequency
monitor are write protected.)
1C Trim control increase (ON: d4-02 frequencies are added to analog frequency references.)
1D Trim control decrease (ON: d4-02 frequencies are subtracted from analog frequency references.)
1E Analog frequency reference sample/hold
1F Frequency reference terminal 13/14 selection (ON: selects terminal 14)
20 2F
External fault (Desired settings possible)
Input mode: NO contact/NC contact,
Detection mode: Normal/during operation
Stopping method: Deceleration to stop, coast to stop, emergency stop or continue operation.
60 DC injection braking command (ON: Performs DC injection braking)
61 External speed search command 1: Maximum output frequency (ON: speed search)
62 External speed search command 2: Set frequency (ON: speed search)
64 External speed search command 3
65 KEB (deceleration at momentary power loss) command (NO contact)
66 KEB (deceleration at momentary power loss) command (NO contact)
77 Speed control (ASR) proportional gain switch (ON: C5-03)
7