Yaskawa MotionWorks IEC Hardware - Manual (Page 147)

MotionWorks IEC Hardware Configuration – 2013-03-26 144
Hex Code Description
ErrorClass AxisErrorID ErrorClass+AxisErrorID output from
MC_ReadAxisError
AlarmID AlarmID output from Y_ReadAlarm
app 340C 010D Internal PLC Error: Unknown POU type
app 340C 010E Cannot insert a POU because there is no project.
app 340C 010F Internal PLC Error: Cannot insert a POU because it does
not belong to the project.
app 340C 0110 Internal PLC Error: Cannot insert a POU.
app 340C 0111 Internal PLC Error: Invalid POU type
app 340C 0112 Internal PLC Error: Memory reorganization not
possible; PLC stopped.
app 340C 0113 Internal PLC Error: SPG defined more than once.
app 340C 0114 Internal PLC Error: Memory error for initialized data of
POU.
app 340C 0115 Internal PLC Error: Retain CRC failed. Possible reasons:
(1) actual project does not have any retain data, (2)
actual project is 'old style' without retain CRC (3) PLC
isn't in STOP mode
app 340C 0116 Internal PLC Error: FB defined more than once.
app 340C 0117 Internal PLC Error: Not all POU sent.
app 340C 0118 Internal PLC Error: No program memory defined.
app 340C 0119 Internal PLC Error: Invalid FB number.
app 340C 011A Internal PLC Error: Invalid PG number.
app 340C 011B Internal PLC Error: Invalid SPG number.
app 340C 011C POU uses more than 80 percent of POU memory.
app 340C 011D Project uses more than 80 percent of program
memory.
app 340C 011E Internal PLC Error: Invalid function or function block.
app 340C 011F Internal PLC Error: Invalid firmware function or
function block.
app 340C 0120 Internal PLC Error: Invalid program.
app 340C 0121 Internal PLC Error: Invalid change of mode.
app 340C 0122 Internal PLC Error: Unknown system mode! PLC
stopped!
app 340C 0123 Stack overflow. Increase stack size.
app 340C 0124 System error in module. Check debugging output via
controller's web interface.
app 340C 0125 System error in module. Check debugging output via