Pin assignments, Rs-422/485 ports – Grass Valley Karrera Video Production Center Installation v.4.1 User Manual
Page 78

78
KARRERA — Installation & Service Manual
Section 4 — System Cabling
relay coils to clamp inductive spikes. Shielded cable is recommended for
the connection from the switcher to the user tally system.
Pin Assignments
RS-422/485 Ports
Eight RS-422/485 ports are available on the rear of the Karrera 8-RU and 4
RU Frames, and can be used to control various devices, or for switcher
control by an external controller.
Note
The Frame serial port pinout is automatically configured based on assign-
ment. The Frame is the bus controller when controlling external devices,
PBus, and serial tally. The Frame is a tributary when being controlled by an
editor.
Table 3. Tally and GPI Output Specifications
Maximum current for any one output
1 amp AC/DC
Maximum current for any one common
2 amp AC/DC
Maximum off (open circuit) voltage between output and common
60 Volts peak
Maximum voltage between any point and ground (chassis)
60 Volts peak
Table 4. RS-422/485 Pinouts
Socket
Pin
Bus Controller
Tributary
1
Chassis Ground
Chassis Ground
2
RxA (-)
TxA (-)
3
TxB (+)
RxB (+)
4
Signal Ground
Signal Ground
5
Not used
Not used
6
Signal Ground
Signal Ground
7
RxB (+)
TxB (+)
8
TxA (-)
RxA (-)
9
Chassis Ground
Chassis Ground
Pin 1
Pin 5
Pin 6
Pin 9
D-9 Female