Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 137)

KARRERA — Installation & Service Manual 137
Engineering Setups
2. Touch the Suite 1 or Suite 2 button ( Figure 86 ) to change suite delegation.
3. Re-acquire the CS outputs by touching the CS buttons (CS-1, CS-2, etc.).
It is recommended at this point that you save a new Eng Setup file that
includes these changes.
ClipStore Config Menu
The ClipStore Config menu is used to configure the ClipStore input/output
parameters and read those input/output parameters from, or send them to,
the ClipStore server (
Figure 87 ).
Figure 87. ClipStore Configuration Menu
Read from ClipStore button —Updates the Eng Setup, ClipStore Config menu
with the current parameter settings for the configured ClipStore server
channels (
Figure 87 ).
Send to ClipStore button —Sends all parameter and system settings required by
ClipStore to record, edit, and control clips to the server. Any changes to the
Record Setup or Replay Setup parameter settings will also be sent to the
ClipStore server (
Figure 87 ). A dialog is displayed when this button is
pressed ( Figure 88 ), stating that all clips will be ejected as part of this oper-
ation; keep this in mind if considering this operation during a broadcast.