Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 234)

234 KARRERA — Installation & Service Manual
Section 7 — Maintenance
Figure 172. Joystick Calibration Instructions 2, 3, EMEM Area
Note Pressing the Menu button cancels the Joystick calibration mode, but may
leave the Joystick in an un-calibrated state. Complete the entire calibration
procedure to ensure normal operation.
Panel Saver Time Adjustment
1. On any EMEM area, press Menu , Page . This shows a list of menu items
that are selected with the buttons below the display ( Figure 173 , left).
Figure 173. Karrera Calibration Menu, EMEM Area
2. Select Panel Saver (press Bank 3/7 ) to adjust the panel saver timing
( Figure 173 , right).
3. Once in panel saver mode, select the time period (in minutes) of
inactivity required to initiate the panel saver mode using the buttons
below the display (
Figure 174 ). The illuminated button indicates the
current setting.
Figure 174. Panel Saver Mode, EMEM Area
8804_07
9 Bank ank
3 / 7
7 8 Lrn
Joystick Calibration
Move joystick to the bottom right corner.
Twist the joystick clockwise.
Press LRN to continue.
9 Bank ank
3 / 7
7 8 Lrn
Joystick Calibration
Move joystick to the center.
Do not twist the joystick.
Press LRN to complete.
b
9 Bank ank
3 / 7
7 8 Lrn
a c
Joystick Calibration
Move joystick to the top left corner.
Twist the joystick counterclockwise.
Press LRN to continue.
Me Menu
Pause Pause 9 Bank ank
3 / 7
7 8 Lrn
Menu 1
Trans
Rate
Stripe
Delg
Panel
Mem
Macro
Me Menu
Pause Pause 9 Bank ank
3 / 7
7 8 Lrn
Menu 2
Panel
Saver IP
Addr
Calib Time Date
8804_08
8804_09
9 Bank ank
3 / 7
7 8 Lrn
Panel Saver
20 30 45 60 10