Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 253)

KARRERA — Installation & Service Manual 253
Video Processor Frame Maintenance
VP Frame Processor Board Replacement
When replacing the Karrera Video Processor Frame control processor
board, in either the 4U or 8U Frame, verify that the S2 Boot Mode Dipswitch
settings are all in the up or
Normal position. The dipswitch is located next to
the Flash card on the control processor board, as shown in Figure 202 .
Figure 202. Karrera Control Processor Board - S2 Boot Mode Dipswitch Location
CAUTION If the Dipswitch settings are not in the up or Normal position, the system may
not boot.
Figure 203 shows the Video Processor Frame Boot Mode switch settings in
the Up (normal operation) position.
Figure 203. Karrera Control Processor Board - Boot Mode Switch Setting
8448_60_Ct
rlB
rdDip
S
witch
All Up = Normal Operation
8623266_88
Video Processor Frame
Boot Mode DIP Switch
1 2 3 4 5 6 7 8