Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 110)

110 KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
Remote Aux Panel Registration
Note Do not confuse the Local Aux Panel, which is considered a Control Panel
Stripe, with Remote Aux Panels, which are small panels used to change Aux
Bus sources from a different location. The Local Aux Panel Stripe is not con-
figured with the following menus.
1. Touch Eng Setup , Node Settings , Remote Aux IP Network ( Figure 69 ).
Figure 69. Remote Aux IP Network Menu
2. Touch an available set of buttons and enter an Aux Panel Name and IP
address of each Aux Panel.
3. Identify the type of Remote Aux Panel (Single or Multi- Destination).
4. You can assign the component to a suite and control surface now if you
wish, but it is recommended to initially configure your Karrera system
as a single suite. Later, you can modify the configuration for multi-suite
operation.
Remote Aux Panel Configuration
Each Remote Aux Panel needs to be configured, which involves identifying
what Aux Bus(es) it will be able to control, and which sources will be avail-
able on that panel’s button. See Remote Aux Logical Map Menu
on page 192
and Remote Aux Button Map Menu on page 193 for more information.