Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 125)

KARRERA — Installation & Service Manual 125
Engineering Setups
Figure 76. On Air Tally Menu, PGM/PST Outputs
Calc On - Turns the delegated Tally Calculator on or off. When on, the Calcu-
lation Enables button on the separate Relay Assign Menu will be activated for
that calculator.
Groups Enabled - Reports which Tally Groups are currently assigned for that
calculator, by group letter (A, B, C, D, corresponding to Tally/GPI connec-
tors 1-4 on the rear of the Karrera Video Processor Frame). To Enable a Tally
Relay Group, it must first be turned on, using the
Calc On button for that cal-
culator.
The first tally calculator name is fixed to On Air . Since the On Air Calculator
is restricted the Look Ahead and Bus buttons are disabled (grayed out).
Creating an On Air Tally Calculator Using MEs or PGM/PST
1. If necessary, login to the desired suite ( Eng Setup , Eng Login ).
2. Touch Eng Setup , Switcher Tally , On Air Tally to access the On Air Tally menu.
The Suite button for the current suite will be highlighted.
3. Touch a Tributary button on the right.
4. Touch an ME or PGM/PST button on the left.
5. Touch an Output button to assign that output of that ME or PGM/PST
to that tributary. The name of the output is displayed on the Tributary
button.