Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 108)

108 KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
IP address. You can restore the panel to its factory default address, if neces-
sary, with the following procedure.
1. Disconnect the Ethernet cable and the AC power cable from the Remote
Aux Panel.
2. Reconnect only the AC power cable. The panel will enter a diagnostic
mode.
3. Push down and hold any panel button. After three seconds panel
buttons will light up sequentially, indicating different available
diagnostics.
4. When three buttons illuminate, release the held button. This places the
panel in IP Address reset mode, and one button will be flashing.
5. Press the flashing button. This resets the IP address to factory default.
Registering Karrera System Nodes
When IP addresses have been changed on Karrera system components, or
new components are added, the Video Processor Frame needs to know
what new addresses it will use to communicate with those components.
This is accomplished by registering those addresses with the Frame using
the Karrera Menu application Node Settings Menus.
Menu Panel Registration
Registering the Karrera Menu Panel (or PC running the Karrera Menu
application) with the Frame was described earlier (see Establishing Menu to
Frame Communication
on page 90 ). The Karrera Menu application needs to be
in communication with the Video Processor Frame before other nodes can
be registered.
Control Panel Registration
1. Touch Eng Setup , Node Settings , Control Surfaces ( Figure 68 ).