Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 133)

KARRERA — Installation & Service Manual 133
Engineering Setups
Configuring Source Definitions
To configure source definitions for ClipStore return outputs, choose a
source, a source type, an input, and in the case of a key, an Engineering
Name for the source if desired.
The following example demonstrates the configuration of a Summit with
four ClipStore channels. In this example the physical BNC connections
from the ClipStore to the Karrera Frame are Inputs 25-32.
ClipStore can record Video only, Key only, or Video/Key clips. To do this,
both a video and a key for the video must be configured for each ClipStore
channel.
To configure a source for as a ClipStore Video input:
1. Go to the Eng Setup, Source Definition menu ( Figure 83 ).
Figure 83. ClipStore Source Definition
2. From the Source List, touch a source ( Figure 83 ).
3. Use the default video input (Video In:) or change it using the Video Input
data pad.
4. Touch the Linear Key button to select it.
5. Use the Key Input data pad (or soft knob) to select the source number of
the Key source you will use for the ClipStore channel.