Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 134)

134 KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
6. Configure the Source Type:
a. Touch the Device mode button in the Source Type pane ( Figure 84 ).
b. Touch the External Device data pad, the External Device List is
displayed ( Figure 84 ).
Figure 84. ClipStore External Device List
c. Touch a CS channel to select it ( Figure 84 ).
The External Device List closes and the Engineering Name is filled in
with the ClipStore External Device name automatically.
To configure a source as a ClipStore Key input (Key input to the ClipStore
Video input created earlier):
1. From the Source List, touch a source ( Figure 85 ).
2. Touch the No Key button in the Key Mode pane to select it (if not
selected).
3. Use the default video input (Video In:) or change it using the Video Input
data pad.
4. Touch the Direct mode button in the Source Type pane to select it.
5. Give the ClipStore key input an Engineering Name if desired (CS-1K,
Figure 85 ), by touching the Engineering Name data pad and entering the
name in the pop-up keyboard.