Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 136)

136 KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
Aux 5, Aux 5a and Aux 5b will be paired as a ClipStore Video/Key pair
when the ClipStore button is enabled.
1. Go to the Outputs menu ( Figure 86 ) by touching Eng Setup , Outputs .
Figure 86. ClipStore Output Configuration
2. Select the odd numbered output (first Aux bus output assigned for a
video/key pair must be odd/fill) that you wish to use as the input to
ClipStore (
Figure 86 ). Then select Aux as the Output Type and the
desired logical Aux bus.
3. Touch one of the ClipStore buttons ( Figure 86 ).
4. Repeat the preceding steps for each channel of ClipStore.
Note You only need to configure all channels as video/key if you wish to record on
all channels.
The Engineering Names for each ClipStore channel will appear in the
Karrera Local Aux Module and/or can be button mapped as desired.
When acquiring CS channels in another suite, before reassigning CS chan-
nels:
1. In the Outputs menu, deselect the CS channels to be acquired
(
Figure 86 ).