Changing menu panel ip address, Setting 32-crosspoint remote aux panel ip address, Setting the ip address – Grass Valley Karrera Video Production Center Installation v.4.1 User Manual
Page 104
104
KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
Changing Menu Panel IP Address
Set the Karrera Menu Panel IP addresses using the Windows XP interface.
You may use the touch screen to access the Windows settings but you will
need to use a mouse and keyboard connected to the Menu panel for
entering the IP address values. To set the Menu panel address:
1.
Go to
Eng Setup
,
Status
and touch the
Minimize Menu
button. This will take
you to the Windows desktop.
2.
Go to
Start
,
Settings
,
Network Connection, Local Area Connection, Properties,
and
follow the standard Windows IP address setting procedure.
regarding additional configuration
steps required.
Setting 32-Crosspoint Remote Aux Panel IP Address
The default IP addresses of Remote Aux Panels are set to at the factory
before shipment will not work with a Karrera system whose other compo-
nents are set to defaults. Typically, Karrera systems are equipped with more
than one Remote Aux Panel. If more than one Remote Aux Panel will be
used on your Karrera system, you will need to change each panels’ IP
addresses so none are duplicated, and this must be done before you
connect them to the network. This will require a mouse and keyboard con-
nected to a PC disconnected from the network.
Check with your network administrator to learn what IP addresses should
be used at your facility.
Setting the IP Address
A PC equipped with an Ethernet interface and a web browser is required to
change Remote Aux Panel IP addresses.
1.
With the PC disconnected from all facility networks, connect the PC’s
Ethernet port directly to the Remote Aux Panel.
Note
A crossover Ethernet cable (Tx/Rx pair crossed) is needed when connecting
a PC directly to the Remote Aux Panel without a hub intermediary.
2.
Start the web browser, enter the default IP address (192.168.1.2) in the
address field, and press
Enter
. If the address is found, a Panel
Description screen similar to
will appear.
Note
If the Remote Aux Panel address is not found, you may need to reset the
panel to its defaults (see