Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 101)

KARRERA — Installation & Service Manual 101
Network Configuration
ured to use the old frame IP address. You will need to go to each device and
change the address they use to communicate with the Video Processor
Frame.
Changing Image Store IP Address
The Image Store IP address can be changed using the Video Processor
Frame web page. See Setting IPs with Device Web Pages
on page 99 for more
information.
Changing Control Panel IP Addresses
A Karrera Control Panel’s IP address can be changed using various
methods:
• GV Switcher Installer program (see Setting IPs with the GV Switcher
Installer Program
on page 95 ).
• the Karrera Control Panel webpage (see Set IP Procedure Using Device
Web Pages
on page 99 ),
• the Grass Valley NetConfig application, or
• Control Panel IP Address mode on a panel EMEM area (see below).
Control Panel EMEM IP Address Mode
A Control Panel’s EMEM area can be used to change the IP address of the
that panel, set its Subnet Mask and Gateway addresses, and enter the IP
address the Control Panel will use to communicate with the Video Pro-
cessor Frame.
Setting The Control Panel’s IP Address
1. On any EMEM area, press Menu , Page . This shows a list of menu items
that are selected with the buttons below the display ( Figure 59 , left).
Figure 59. Karrera Panel IP Address Mode Selection, EMEM Area
2. Select IP Addr (press Lrn ) to enter IP Address mode ( Figure 59 , right).
Me Menu
Pause Pause 9 Bank ank
3 / 7
7 8 Lrn
Menu 1
Trans
Rate
Stripe
Delg
Panel
Mem
Macro
Me Menu
Pause Pause 9 Bank ank
3 / 7
7 8 Lrn
Menu 2
Panel
Saver IP
Addr
Calib Time Date
8804_06