Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 230)

230 KARRERA — Installation & Service Manual
Section 7 — Maintenance
3. Touch the New Auth Code for Perm data pad and enter the code on the pop-
up keypad.
Note System ID and Authorization Codes are alphanumeric and need to be entered
exactly. Authorization codes do not use the letters “o” or “l” to avoid confu-
sion with the numbers “0” and “1”. The dashes in authorization codes are
required for use.
4. Touch the button labeled either Replace or Install next to the new
authorization code. The codes will be added and the expiration date of
any maintenance contract will be indicated. If you do not believe the
option statuses reported are correct, contact Grass Valley Customer
Support to resolve the issue.
5. If options were removed, reset the Video Processor Frame.
Note When an option is removed, it remains operational until the Video Processor
Frame is reset or power cycled. When an option is added, it becomes opera-
tional immediately without requiring a Frame reset.
6. Write down the authorization codes, specifying which system they
apply to, and store this information in a safe place, should you need to
re-enter the codes at some time in the future.
Temporary Authorizations
For demonstration or rental, optional features can be authorized tempo-
rarily. Once you have obtained the temporary authorization code, enter it
on the Karrera system using the procedure described above, except you
first select one of the
Temp buttons. Temporary authorization information is
displayed on the right portion of the menu. Up to four temporary authori-
zations are allowed at a time. Temporary authorization features that are
removed remains active until the Video Processor Frame is reset.
Control Panel Maintenance
Control Panel Adjustments
Lever Arm Calibration
1. On any EMEM area, press Menu , Page . This shows a list of menu items
that are selected with the buttons below the display ( Figure 167 , left).