Grass Valley Karrera Video Production Center v.4.0 - Manual (Page 214)

214 KARRERA — User Manual
Section 6 — Switching Basics
Figure 107. Trans Lock Button—Source Ops, Aux Buses Menu
Setting Wipe Transition Parameters
1. Go to the Wipes menu in the Karrera Menu Panel or press the Wipe
button in the Multi-Function area and set the wipe parameters for the
ME(s) you will use for the aux bus.
2. Select the wipe pattern to be used.
CAUTION When two partitions or more are released for aux bus wipe transitions, it is
very important to make all wipe parameters the same because the dynamic
assignment of ME partitions will not guarantee that an allocated partition will
supply the transition resource for a specific aux bus.
Allocating Resources and Setting up the Transition
Note The DoubleTake option is required for Aux bus transitions.
Aux bus transitions use the allocated resources only during the transition.
Any Aux bus can then use the resource as it frees the resource after the tran-
sition.
When resources are allocated, the ME Mode menu still allows for the
keyers to be used on the resource. If keyers are cut on they will only be
visible on the Aux bus during the transition.