Grass Valley Karrera Video Production Center v.4.0 - Manual (Page 139)

KARRERA — User Manual 139
Macros
Inserting a Delay
While recording a macro, press the Ins Delay button then press the keyer
source select button of the desired delay time. The 2nd Shift button (3rd and
4th are undefined for this function) splits the time interval selection
between fields (upper key row) and seconds (lower key row). Multiple
selections can be made to insert longer delays in both fields and seconds.
Playing Back a Macro Register
1. Turn on Macro mode with the Macro button. If not already on, you may
also want to press the Show (Attach) button to display the macro names
on the source name displays.
2. Select the macro to be played
• On the Control Panel, press the keyer button of the desired macro
register. The
Shift button accesses shifted macros (2nd, 3rd, and 4th).
• On the Macro menu, touch the macro register button of the desired
macro register, then touch the
Play button.
Attaching a Macro to a Panel Button Using the Control Panel
Pre-Attach a Macro
1. Delegate the bus rows to Macro by pressing the Macro button (see
Figure 65 on page 135 ).
2. Press and hold down the macro button to be attached.
3. Press the keyer row button to which the macro will be attached (if Show
(Attach) is on, the panel button will flash until Show is turned off).
Post-Attach a Macro
1. Delegate the bus rows to Macro by pressing the Macro button (see
Figure 65 on page 135 ).
2. Press and hold down the keyer row button to which the macro is to be
attached.
3. Press the macro button to be attached (if Show (Attach) is on, the newly
defined macro button will flash until Show is turned off).
Note Macros attach to physical buttons, not to the delegated target of that button.
This means, for example, if you attach a macro to the Chroma Key button,
pressing that button runs the macro regardless of which keyer the Transition
area has been delegated to control.
To attach multiple macros to the same button, select another attach mode,
then select the macro register of the additional macro, then touch the button