Grass Valley Karrera Video Production Center v.4.0 - Manual (Page 112)

112 KARRERA — User Manual
Section 3 — Video Mix/Effects
If your E-MEM effect in the Master E-MEM only has one keyframe, you
must insert an additional keyframe to run the entire eDPM effect timeline.
Note For E-MEMs learned using versions earlier than 2.0 to work properly, you
must reconstruct a timeline for the proxy sublevels to run. The proxy sublevel
register has been created but is limited to a single keyframe.
Recalling and editing eDPM timelines from the Master E-MEM timeline is
truly independent and does not effect the keyframes in the eDPM. Inserting
keyframes in the Master E-MEM’s eDPM sub-level timeline creates a key-
frame which is a ‘proxy’ to drive the eDPM’s timeline.
• When running an eDPM timeline from the Master E-MEM timeline,
pauses on the eDPM side are ignored.
• Start delays on the Master (Switcher) side are executed before eDPM
timeline.
eDPM Partitioning
The eDPM partition boundary is a sub-level in the eDPM Primary partition.
Figure 55 shows the Select All , EDPM Pri and EDPM Sec , and PART buttons.
These buttons are used to enable/disable the partition settings and control
the Channel settings in the Picture, Combiner menu.
Note Unlike Master E-MEM Part level, the PART in eDPM is a sub-level of eDPM
Primary and cannot be enabled unless eDPM Primary is also enabled.