H3C Technologies H3C S5120 Series Switches - Manual (Page 652)

1-9
To do… Use the command… Remarks
Configure the output rules of
the system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to Default Output Rules
of System .
Configure the format of the time
stamp
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Optional
By default, the time stamp
format for log, trap and
debugging information is date.
Enabling the display of system information on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the associated
display function in order to display the output information on the monitor terminal.
Follow these steps to enable the display of system information on a monitor terminal:
To do… Use the command… Remarks
Enable the monitoring of
system information on a
monitor terminal
terminal monitor
Required
Enabled on the console and
disabled on the monitor
terminal by default.
Enable the display of
debugging information on a
monitor terminal
terminal debugging
Required
Disabled by default
Enable the display of log
information on a monitor
terminal
terminal logging
Optional
Enabled by default
Enable the display of trap
information on a monitor
terminal
terminal trapping
Optional
Enabled by default
Outputting System Information to a Log Host
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name Optional
Refer to Table 1-2 for default
channel names.
Specify a log host and
configure the parameters when
system information is output to
the log host
info-center loghost host-ip
[ port port-number ] [ channel
{ channel-number |
channel-name } | facility
local-number ] * Required
By default, the system does not
output information to a log host.
If you specify to output system
information to a log host, the