H3C Technologies H3C S5120 Series Switches - Manual (Page 271)

1-6
Follow the step below to use another username to log in to the FTP server:
To do… Use the command… Remarks
Use another username to relog in after
successfully logging in to the FTP server
user username [ password ] Optional
Maintaining and Debugging an FTP Connection
After a device serving as the FTP client has established a connection with the FTP server (For how to
establish an FTP connection, refer to Establishing an FTP Connection .), you can perform the following
operations to locate and diagnose problems encountered in an FTP connection:
To do… Use the command… Remarks
Display the help information of
FTP-related commands supported
by the remote FTP server
remotehelp [ protocol-command ] Optional
Enable information display in a
detailed manner
verbose
Optional
Enabled by default
Enable FTP related debugging when
the device acts as the FTP client
debugging
Optional
Disabled by default
Terminating an FTP Connection
After the device serving as the FTP client has established a connection with the FTP server (For how to
establish an FTP connection, refer to Establishing an FTP Connection .), you can use any of the
following commands to terminate an FTP connection:
To do… Use the command… Remarks
Terminate the connection to the FTP
server without exiting FTP client view
disconnect
Optional
Equal to the close
command.
Terminate the connection to the FTP
server without exiting FTP client view
close
Optional
Equal to the disconnect
command.
Terminate the connection to the FTP
server and return to user view
bye
Optional
Equal to the quit command
in FTP client view.
Terminate the connection to the FTP
server and return to user view
quit
Optional
Available in FTP client view,
equal to the bye command.
FTP Client Configuration Example
Network requirements
z As shown in Figure 1-2 , use Device as an FTP client and PC as the FTP server. Their IP addresses
are 10.2.1.1/16 and 10.1.1.1/16 respectively. An available route exists between Device and PC.