H3C Technologies H3C S5120 Series Switches - Manual (Page 565)

1-16
The procedure of configuring NTP authentication on a server is the same as that on a client, and the
same authentication key must be configured on both the server and client sides.
Displaying and Maintaining NTP
To do… Use the command… Remarks
View the information of NTP
service status
display ntp-service status Available in any view
View the information of NTP
sessions display ntp-service sessions
[ verbose ]
Available in any view
View the brief information of the
NTP servers from the local
device back to the primary
reference source
display ntp-service trace Available in any view
NTP Configuration Examples
Configuring NTP Client/Server Mode
Network requirements
Perform the following configurations to synchronize the time between Device B and Device A:
z The local clock of Device A is to be used as a reference source, with the stratum level of 2.
z Device B works in the client/server mode and Device A is to be used as the NTP server of Device
B.
Figure 1-7 Network diagram for NTP client/server mode configuration
Configuration procedure
1) Configure IP addresses for interfaces (omitted)
2) Configuration on Device B:
# View the NTP status of Device B before clock synchronization.
display ntp-service status
Clock status: unsynchronized
Clock stratum: 16
Reference clock ID: none
Nominal frequency: 100.0000 Hz
Actual frequency: 100.0000 Hz
Clock precision: 2^18