H3C Technologies H3C S5120 Series Switches - Manual (Page 524)

1-3
Displaying and Maintaining HABP
To do… Use the command… Remarks
Display HABP configuration information display habp Available in any
view
Display HABP MAC address table
entries display habp table Available in any
view
Display HABP packet statistics display habp traffic Available in any
view
HABP Configuration Example
Network requirements
As shown in Figure 1-2 , Switch A is the management device and connects two access devices: Switch
B and Switch C. Configure HABP so that Switch A can manage Switch B and Switch C.
z Configure Switch A as the HABP server, allowing HABP packets to be transmitted in VLAN 2.
z Enable HABP client on Switch B and Switch C.
z On switch A, set the interval to send HABP request packets to 50 seconds.
Figure 1-2 Network diagram for HABP configuration
Configuration procedure
1) Configure Switch A
# Configure the IP addresses of the involved interfaces. (Omitted)
# Enable HABP.
system-view