H3C Technologies H3C S7500E Series Switches - Manual (Page 88)

4-3
To do… Use the command… Remarks
Configure an
SNMP group
snmp-agent group { v1 |
v2c } group-name
[ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ]
[ acl acl-number ]
Indirectly
Add a user to the
SNMP group
snmp-agent usm-user { v1
| v2c } user-name
group-name [ acl
acl-number ]
SNMPv2C. The community
name configured on the NMS
should be consistent with the
username configured on the
agent.
The indirect configuration
approach is for SNMPv3.
The device supports three SNMP versions: SNMPv1, SNMPv2C and SNMPv3. For more information
about SNMP, see SNMP Configuration in the Network Management and Monitoring Configuration
Guide.
NMS Login Example
In this example, iMC is used as the NMS for illustration.
Configuration on the device
# Assign 1.1.1.1/24 for the IP address of device. Make sure the device and the NMS can reach each
other. (Configuration steps are omitted.)
# Enter system view.
system-view
# Enable the SNMP agent.
[Sysname] snmp-agent
# Configure an SNMP group.
[Sysname] snmp-agent group v3 managev3group read-view test write-view test
# Add a user to the SNMP group.
[Sysname] snmp-agent usm-user v3 managev3user managev3group
Configuration on the NMS
On the PC, start the browser. In the address bar, enter http://192.168.4.112:8080/imc, where
192.168.4.112 is the IP address of the iMC.