H3C Technologies H3C S7500E Series Switches - Manual (Page 66)

3-27
Object Requirements
Configure the IP address of the VLAN interface, and make sure the SSH
server and client can reach each other.
SSH server
Configure the authentication mode and other settings.
Run the SSH client program.
SSH client
Obtain the IP address of the VLAN interface on the server.
By default, the device is enabled with the SSH server and client functions.
z On a device that serves as the SSH client, you can log in to an SSH server to perform operations
on the server.
z On a device that serves as the SSH server, you can configure the authentication mode and user
level for SSH users. By default, password authentication is adopted for SSH login, but no login
password is configured. Therefore, you cannot log in to the device through SSH by default. Before
you can log in to the device through SSH, you need to log in to the device through the console port
and configure the authentication mode, user level, and common settings.
This section includes these topics:
z Configuring the SSH Server
z Configuring the SSH Client to Log In to the SSH Server
Configuring the SSH Server
Configuration prerequisites
You have logged in to the device, and want to log in to the device through SSH in the future.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For how to log in to the device with default configuration, see Configuration
Requirements .
Configuration procedure
Follow these steps to configure the device that serves as an SSH server:
To do… Use the command… Remarks
Enters system view system-view —
Create local key pair(s)
public-key local create { dsa |
rsa }
Required
By default, no local key pair(s) are
created.
Enable SSH server ssh server enable
Required
By default, SSH server is disabled.
Exit to system view quit —