H3C Technologies H3C S7500E Series Switches - Manual (Page 179)

11-17
To do… Use the command… Remarks
Clear the 16-bit interface indexes
saved but not in use in the current
systems of the active SRPU and
the standby SRPU (distributed
device)
reset unused porttag
Required
Available in user view.
Clear the 16-bit interface indexes
saved but not in use in the current
systems of all member devices
(distributed IRF device)
reset unused porttag
Required
Available in user view.
A confirmation is required when you execute this command. If you fail to make a confirmation within 30
seconds or enter N to cancel the operation, the command will not be executed.
Configuring the System Load Sharing Function
The S7500E series Ethernet switches support the load sharing function.
z When the system load sharing function is enabled, the active SRPU and the standby SRPU share
the traffic that needs inter-card forwarding.
z When the system load sharing function is disabled, only the active SRPU forwards the traffic that
needs inter-card forwarding.
Follow the steps below to enable the system load sharing function:
To do… Use the command… Remarks
Enter system view system-view —
Enable the system load sharing
function
loadsharing enable
Optional
Disabled by default.
z Load sharing is applicable to unicast traffic only.
z The S7502E switches are designed to work in the load sharing mode, and do not support the
command.