H3C Technologies H3C S7500E Series Switches - Manual (Page 64)

3-25
To do… Use the command… Remarks
Set the idle-timeout
timer
idle-timeout minutes
[ seconds ]
Optional
The default idle-timeout is 10
minutes for all user interfaces.
The system automatically
terminates the user’s connection if
there is no information interaction
between the device and the user in
timeout time.
Setting idle-timeout to 0 disables
the timer.
Specify a command
to be automatically
executed when a user
logs in to the current
user interface
auto-execute command
command
Optional
By default, command
auto-execution is disabled.
The system automatically executes
the specified command when a
user logs in to the user interface,
and tears down the user
connection after the command is
executed. If the command triggers
another task, the system does not
tear down the user connection until
the task is completed. A telnet
command is usually specified to
enable the user to automatically
telnet to the specified device.
The auto-execute command command may disable you from configuring the system through the
user interface to which the command is applied. Therefore, before configuring the command and
saving the configuration (by using the save command), make sure that you can access the device
through VTY, TTY, console, or AUX interfaces to remove the configuration when a problem occurs.
Configuring the Device to Log In to Another Device as a Telnet Client
Configuration prerequisites
You have logged in to the device.