Displaying and maintaining the tftp client, Network requirements, Configuration procedure – H3C Technologies H3C S7500E Series Switches User Manual
Page 118
7-4
z
If no primary IP address is configured on the source interface, no TFTP connection can be
established.
z
If you use the ftp client source command to first configure the source interface and then the
source IP address of the packets of the TFTP client, the new source IP address will overwrite the
current one, and vice versa.
Displaying and Maintaining the TFTP Client
To do…
Use the command…
Remarks
Display the configuration of the
TFTP client
display tftp client configuration
Available in any view
TFTP Client Configuration Example (Distributed Device)
Network requirements
z
As shown in
, use a PC as the TFTP server and Device as the TFTP client. Their IP
addresses are 1.2.1.1/16 and 1.1.1.1/16 respectively. An available route exists between Device
and PC.
z
Device downloads a startup file from PC for upgrading and uploads a configuration file named
config.cfg to PC for backup.
Figure 7-2 Smooth upgrading using the TFTP client function
Configuration procedure
1) Configure PC (TFTP Server), the configuration procedure is omitted.
z
On the PC, enable the TFTP server
z
Configure a TFTP working directory
2) Configure Device (TFTP Client)