H3C Technologies H3C S7500E Series Switches - Manual (Page 153)

10-9
Table 10-1 Default patch names for different card types
Product Card type PATCH-FLAG Default patch name
mpu PATCH-MPU patch_mpu.bin
lpb PATCH-LPB patch_lpb.bin S7500E
lpr PATCH-LPR patch_lpr.bin
The loading and installation are performed on all cards that are in position and OAM CPU, so before
these operations, save the patch files for the active main board (AMB) and interface card to the root
directory of the AMB's storage medium, and save the patch files for the standby main board (SMB) to
the root directories of the SMB's storage medium. Make sure the patch files saved on the AMB and
SMB are the same.
One-Step Patch Installation
To install patches in one step, use the patch install command. After you execute the command, the
system displays the message "Do you want to continue running patches after reboot? [Y/N]:".
z Entering y or Y: All the specified patches are installed, and turn to the RUNNING state from IDLE.
This equals execution of the commands patch location, patch load, patch active, and patch
run. The patches remain RUNNING after system reboot.
z Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE.
This equals execution of the commands patch location, patch load and patch active. The
patches turn to the DEACTIVE state after system reboot.
Follow these steps to install the patches in one step:
To do… Use the command… Remarks
Enter system view system-view —
Install the patches in one step patch install patch-location Required
z The patch matches the card type and software version.
z The patch install command changes the patch file location specified with the patch location
command to the directory specified by the patch-location argument of the patch install command.
z To uninstall all patches in one operation, use the undo patch install command, which has the
same effect as Step-by-Step Patch Uninstallation .