H3C Technologies H3C S7500E Series Switches - Manual (Page 81)

3-42
To do… Use the command… Remarks
Configure the
baud rate
speed speed-value
Optional
By default ,the baud rate is 9600
bps.
Transmission rate is the number of
bits that the device transmits to the
terminal per second.
Configure the
parity check mode
parity { even | mark | none | odd
| space }
Optional
By default, the parity check mode of
the AUX port is set to none, which
means no check bit.
Configure the stop
bits
stopbits { 1 | 1.5 | 2 }
Optional
By default, the stop bits of the
console port is 1.
Stop bits are the last bits transmitted
in data transmission to
unequivocally indicate the end of a
character. The more the bits are, the
slower the transmission is.
Configure the data
bits
databits { 5 | 6 | 7 | 8 }
Optional
By default, the data bits of the AUX
port is 8.
Data bits is the number of bits
representing one character. The
setting depends on the contexts to
be transmitted. For example, you
can set it to 7 if standard ASCII
characters are to be sent, and set it
to 8 if extended ASCII characters
are to be sent.
Define a shortcut
key for starting a
session
activation-key character
Optional
By default, you can press Enter to
start a session.
Define a shortcut
key for terminating
tasks
escape-key { default | character }
Optional
By default, you can press Ctrl+C to
terminate a task.
Configure
AUX port
properties
Configure the flow
control mode
flow-control { hardware | none |
software }
Optional
By default, the value is none