H3C Technologies H3C S7500E Series Switches - Manual (Page 117)

7-3
the source address of the transmitted packets. The source address of the transmitted packets is
selected following these rules:
z If no source address of the TFTP client is specified, a device uses the IP address of the interface
determined by the matched route as the source IP address to communicate with a TFTP server.
z If the source address is specified with the tftp client source or tftp command, this source
address is adopted.
z If you use the tftp client source command and the tftp command to specify a source address
respectively, the source address configured with the tftp command is used to communicate with a
TFTP server.
The source address specified with the tftp client source command is valid for all TFTP connections
and the source address specified with the tftp command is valid only for the current tftp connection.
Follow these steps to configure the TFTP client:
To do… Use the command… Remarks
Enter system view system-view —
Use an ACL to control the device’s
access to TFTP servers
tftp-server [ ipv6 ] acl acl-number
Optional
By default, no ACL is used to
control the device’s access to
TFTP servers.
Configure the source address of
the TFTP client
tftp client source { interface
interface-type interface-number |
ip source-ip-address }
Optional
A device uses the source address
determined by the matched route
to communicate with the TFTP
server by default.
Return to user view quit —
Download or upload a file in an
IPv4 network
tftp server-address { get | put |
sget } source-filename
[ destination-filename ] [ source
{ interface interface-type
interface-number | ip
source-ip-address } ]
Optional
Available in user view
Download or upload a file in an
IPv6 network
tftp ipv6 tftp-ipv6-server [ -i
interface-type interface-number ]
{ get | put } source-file
[ destination-file ]
Optional
Available in user view