H3C Technologies H3C S7500E Series Switches - Manual (Page 164)

11-2
Device Management Configuration Task List
Complete these tasks to configure device management:
Task Remarks
Configuring the Device Name Optional
Configuring the System Clock Optional
Enabling/Disabling the Display of Copyright Information Optional
Configuring a Banner Optional
Configuring the Exception Handling Method Optional
Rebooting a Device Optional
Scheduled Task Configuration Optional
Configuring Temperature Alarm Thresholds for a board Optional
Clearing the 16-bit Interface Indexes Not Used in the Current System Optional
Configuring the System Load Sharing Function Optional
Enabling Active/Standby Mode for Service Ports on SRPUs Optional
Configuring the Traffic Forwarding Mode of SRPUs Optional
Configuring the Working Mode of LPUs Optional
Enabling the Port Down Function Globally Optional
Enabling Expansion Memory Data Recovery Function on a board Optional
Identifying and Diagnosing Pluggable Transceivers Optional
Configuring the Device Name
The device name is used to identify a device in a network. Inside the system, the device name
corresponds to the prompt of the CLI. For example, if the device name is Sysname, the prompt of user
view is .
Follow these steps to configure the device name:
To do… Use the command… Remarks
Enter system view system-view —
Configure the device name sysname sysname
Optional
The device name is H3C.