H3C Technologies H3C S7500E Series Switches - Manual (Page 61)

3-22
To do… Use the command… Remarks
Exit to system view quit
argument, perform the following
configuration as well:
z For RADIUS and HWTACACS
configuration, see AAA
Configuration in the Security
Configuration Guide.
z Configure the username and
password accordingly on the
AAA server. (For more
information, see AAA
Configuration in the Security
Configuration Guide.)
Create a local user and enter local
user view
local-user user-name By default, no local user exists.
Set the local password
password { cipher | simple }
password
Required
By default, no local password is
set.
Specifies the command level of the
local user
authorization-attribute level
level
Optional
By default, the command level is 0.
Specify the service type for the local
user
service-type telnet
Required
By default, no service type is
specified.
Exit to system view quit —
Configure common settings for VTY
user interfaces
—
Optional
See Configuring Common Settings
for VTY User Interfaces (Optional) .
After you enable command authorization, you need to perform the following configuration to make the
function take effect:
z Create a HWTACACS scheme, and specify the IP address of the authorization server and other
authorization parameters. For more information, see AAA Configuration in the Security
Configuration Guide.
z Reference the created HWTACACS scheme in the ISP domain. For more information, see AAA
Configuration in the Security Configuration Guide.
After you enable command accounting, you need to perform the following configuration to make the
function take effect: