H3C Technologies H3C S7500E Series Switches - Manual (Page 177)

11-15
To do… Use the command… Remarks
Automatically execute the
specified command at the
specified time
schedule job at time [ date ] view
view command
Automatically execute the
specified command after the
specified delay
schedule job delay time view
view command
Optional
Use either command.
Available in user view.
Note that:
z At present, you can specify user view and system view only. To automatically execute the
specified command in another view or automatically execute multiple commands at a time, you
can configure the system to automatically execute a batch file at the specified time (note that you
must provide a complete file path for the system to execute the batch file.).
z The system does not check the values of the view and command arguments. Therefore, ensure
the correctness of the command argument (including the correct format of command and the
correct relationship between the command and view arguments).
z After the specified automatic execution time is reached, the system executes the specified
command in the background without displaying any information except system information such
as log, trap and debug.
z The system does not require any interactive information when it is executing the specified
command. If there is information for you to confirm, the system automatically inputs Y or Yes; if
characters need to be input, the system automatically inputs a default character string, or inputs
an empty character string when there is no default character string.
z For the commands used to switch user interfaces, such as telnet, ftp, and ssh2, the commands
used to switch views, such as system-view, quit, and the commands used to modify status of a
user that is executing commands, such as super, the operation interface, command view and
status of the current user are not changed after the automatic execution function is performed.
z If the system time is modified after the automatic execution function is configured, the scheduled
automatic execution configuration turns invalid automatically.
z Only the last configuration takes effect if you execute the schedule job command repeatedly.
z After you configure this feature on the active SRPU, the configuration is not backed up to the
standby SRPU; after a switchover between the active SRPU and the standby SRPU, this
configuration will be ineffective.
Configuring Temperature Alarm Thresholds for a board
You can set temperature alarm thresholds for a card by using the following commands. When the
temperature of a card reaches the threshold, the device will generate alarms.