H3C Technologies H3C S10500 Series Switches - Manual (Page 52)

37
To do... Use the command... Remarks
Enable the created user profile user-profile profile-name enable
Required
Disabled by default.
NOTE:
•
For more information about the user-profile and user-profile enable commands, see Security
Command Reference.
• A multicast user control policy is functionally similar to a multicast group filter. A difference is that a
control policy can control both multicast joining and leaving of users based on authentication and
authorization, but a multicast group filter is configured on a port to control only multicast joining but not
leaving of users without authentication or authorization.
Enabling the IGMP snooping host tracking function
With the IGMP snooping host tracking function, the switch can record the information of the member
hosts that are receiving multicast traffic, including the host IP address, running duration, and timeout time.
You can monitor and manage the member hosts according to the recorded information.
Enabling the IGMP snooping host tracking function globally
Follow these steps to enable the IGMP snooping host tracking function globally:
To do… Use the command… Remarks
Enter system view system-view —
Enter IGMP-snooping view igmp-snooping —
Enable the IGMP snooping host
tracking function globally
host-tracking
Required
Disabled by default.
Enabling the IGMP snooping host tracking function in a VLAN
Follow these steps to enable the IGMP snooping host tracking function in a VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Enter VLAN view vlan vlan-id —
Enable the IGMP snooping host
tracking function in the VLAN
igmp-snooping host-tracking
Required
Disabled by default.
Displaying and maintaining IGMP snooping
To do... Use the command... Remarks
Display IGMP snooping group
information (in standalone mode)
display igmp-snooping group [ vlan vlan-id ]
[ slot slot-number ] [ verbose ] [ | { begin |
exclude | include } regular-expression ]
Available in
any view