H3C Technologies H3C S10500 Series Switches - Manual (Page 308)

293
[SwitchA] interface vlan-interface 104
[SwitchA-Vlan-interface104] pim ipv6 dm
[SwitchA-Vlan-interface104] mld enable
[SwitchA-Vlan-interface104] quit
# Create a multicast source control policy, policy1, so that multicast flows from Source 2 to FF1E::101 will
be blocked.
[SwitchA] acl ipv6 number 3001
[SwitchA-acl6-adv-3001] rule permit udp source 2::1 128 destination ff1e::101 128
[SwitchA-acl6-adv-3001] quit
[SwitchA] traffic classifier classifier1
[SwitchA-classifier-classifier1] if-match acl ipv6 3001
[SwitchA-classifier-classifier1] quit
[SwitchA] traffic behavior behavior1
[SwitchA-behavior-behavior1] filter deny
[SwitchA-behavior-behavior1] quit
[SwitchA] qos policy policy1
[SwitchA-qospolicy-policy1] classifier classifier1 behavior behavior1
[SwitchA-qospolicy-policy1] quit
# Create a user profile, apply policy1 to the inbound direction of GE 1/0/2 in user profile view, and
enable the user profile.
[SwitchA] user-profile profile1
[SwitchA-user-profile-profile1] qos apply policy policy1 inbound
[SwitchA-user-profile-profile1] quit
[SwitchA] user-profile profile1 enable
# Create RADIUS scheme scheme1; set the service type for the RADIUS server to extended; specify the
IP addresses of the primary authentication/authorization server and accounting server as 3::1; set the
shared keys to 123321; specify that no domain name is carried in a username sent to the RADIUS server.
[SwitchA] radius scheme scheme1
[SwitchA-radius-scheme1] server-type extended
[SwitchA-radius-scheme1] primary authentication 3::1
[SwitchA-radius-scheme1] key authentication 123321
[SwitchA-radius-scheme1] primary accounting 3::1
[SwitchA-radius-scheme1] key accounting 123321
[SwitchA-radius-scheme1] user-name-format without-domain
[SwitchA-radius-scheme1] quit
# Create an ISP domain domain1; reference scheme1 for the authentication, authorization, and
accounting for LAN users; specify domain1 as the default ISP domain.
[SwitchA] domain domain1
[SwitchA-isp-domian1] authentication lan-access radius-scheme scheme1
[SwitchA-isp-domian1] authorization lan-access radius-scheme scheme1
[SwitchA-isp-domian1] accounting lan-access radius-scheme scheme1
[SwitchA-isp-domian1] quit
[SwitchA] domain default enable domain1
# Globally enable 802.1X and then enable it on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2
respectively.
[SwitchA] dot1x
[SwitchA] interface gigabitethernet 1/0/1