H3C Technologies H3C S10500 Series Switches User Manual
Page 427
412
# Enable IPv6 multicast routing and administrative scoping on Switch A, enable IPv6 PIM-SM on each
interface, and enable MLD on the host-side interface VLAN-interface 100.
[SwitchA] multicast ipv6 routing-enable
[SwitchA] pim ipv6
[SwitchA-pim6] c-bsr admin-scope
[SwitchA-pim6] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] pim ipv6 sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 sm
[SwitchA-Vlan-interface101] quit
The configuration on Switch E and Switch I is similar to the configuration on Switch A.
# On Switch B, enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM
on each interface.
[SwitchB] multicast ipv6 routing-enable
[SwitchB] pim ipv6
[SwitchB-pim6] c-bsr admin-scope
[SwitchB-pim6] quit
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] pim ipv6 sm
[SwitchB-Vlan-interface200] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim ipv6 sm
[SwitchB-Vlan-interface101] quit
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] pim ipv6 sm
[SwitchB-Vlan-interface102] quit
[SwitchB] interface vlan-interface 103
[SwitchB-Vlan-interface103] pim ipv6 sm
[SwitchB-Vlan-interface103] quit
The configuration on Switch C, Switch D, Switch F, Switch G, and Switch H is similar to the configuration
on Switch B. (Details not shown)
3.
Configure an admin-scope zone boundary.
# On Switch B, configure VLAN-interface 102 and VLAN-interface 103 to be the boundary of
admin-scope zone 1.
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] multicast ipv6 boundary scope 4
[SwitchB-Vlan-interface102] quit
[SwitchB] interface vlan-interface 103
[SwitchB-Vlan-interface103] multicast ipv6 boundary scope 4
[SwitchB-Vlan-interface103] quit
# On Switch C, configure VLAN-interface 103 and VLAN-interface 106 to be the boundary of
admin-scope zone 2.