Ipv6 pim-sm admin-scope zone configuration example, Network requirements – H3C Technologies H3C S10500 Series Switches User Manual
Page 425
410
(4001::100, FF0E::100)
RP: 1003::2
Protocol: pim-sm, Flag: SPT LOC ACT
UpTime: 00:14:44
Upstream interface: Vlan-interface300
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface105
Protocol: mld, UpTime: 00:14:44, Expires: 00:02:26
# View the IPv6 PIM multicast routing table information on Switch E.
[SwitchE] display pim ipv6 routing-table
Total 1 (*, G) entry; 0 (S, G) entry
(*, FF0E::100)
RP: 1003::2 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:16:56
Upstream interface: Register
Upstream neighbor: 4002::1
RPF prime neighbor: 4002::1
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface102
Protocol: pim-sm, UpTime: 00:16:56, Expires: 00:02:34
IPv6 PIM-SM admin-scope zone configuration example
Network requirements
•
Receivers receive VOD information through multicast. The entire IPv6 PIM-SM domain is divided into
IPv6 admin-scope zone 1, IPv6 admin-scope zone 2, and the IPv6 global zone. Switch B, Switch C,
and Switch D are ZBRs of these three domains respectively.
•
Source 1 and Source 2 send different multicast information to FF14::101. Host A receives the
multicast information only from Source 1, and Host B receives the multicast information only from
Source 2. Source 3 sends multicast information to multicast group FF1E::202. Host C is a multicast
receiver for this multicast group.
•
VLAN-interface 101 of Switch B acts as a C-BSR and C-RP of admin-scope zone 1, which serves the
IPv6 multicast groups with the Scope field value in their group addresses being 4. VLAN-interface
104 of Switch D acts as a C-BSR and C-RP of admin-scope zone 2, which also serves the IPv6
multicast groups with the Scope field value in their group addresses being 4. VLAN-interface 109
of Switch F acts as C-BSRs and C-RPs of the global scope zone, which serves IPv6 multicast groups
with the Scope field value in their group addresses being 14.
•
MLDv1 is required between Switch A, Switch E, Switch I, and their respective receivers.