H3C Technologies H3C S10500 Series Switches - Manual (Page 405)

390
Perform the following configuration on routers that you want to configure as the IPv6 BIDIR-PIM domain
border.
Follow these steps to configure an IPv6 BIDIR-PIM domain border:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure an IPv6 BIDIR-PIM
domain border
pim ipv6 bsr-boundary
Required
By default, no IPv6 BIDIR-PIM
domain border is configured.
Configuring global C-BSR parameters
In each IPv6 BIDIR-PIM domain, a unique BSR is elected from C-BSRs. The C-RPs in the IPv6 BIDIR-PIM
domain send advertisement messages to the BSR. The BSR summarizes the advertisement messages to
form an RP-set and advertises it to all routers in the IPv6 BIDIR-PIM domain. All the routers use the same
hash algorithm to get the RP address corresponding to specific multicast groups.
Perform the following configuration on C-BSR routers.
Follow these steps to configure global C-BSR parameters:
To do… Use the command… Remarks
Enter system view system-view —
Enter IPv6 PIM view pim ipv6 —
Configure the hash mask length c-bsr hash-length hash-length
Optional
126 by default
Configure the C-BSR priority c-bsr priority priority
Optional
64 by default
Configuring C-BSR timers
The BSR election winner multicasts its own IPv6 address and RP-Set information through bootstrap
messages within the entire zone it serves. The BSR floods bootstrap messages throughout the network at
the interval of BS (BSR state) period. Any C-BSR that receives a bootstrap message retains the RP-set for
the length of BS timeout, during which no BSR election takes place. If no bootstrap message is received
from the BSR before the BS timeout timer expires, a new BSR election process is triggered among the
C-BSRs.
Perform the following configuration on C-BSR routers.
Follow these steps to configure C-BSR timers:
To do… Use the command… Remarks
Enter system view system-view —
Enter IPv6 PIM view pim ipv6 —
Configure the BS period c-bsr interval interval
Optional
For the default value, see the note
after this table.