H3C Technologies H3C S10500 Series Switches User Manual
Page 309
294
[SwitchA-GigabitEthernet1/0/1] dot1x
[SwitchA-GigabitEthernet1/0/1] quit
[SwitchA] interface gigabitethernet 1/0/2
[SwitchA-GigabitEthernet1/0/2] dot1x
[SwitchA-GigabitEthernet1/0/2] quit
3.
Configure Switch B
# Globally enable MLD snooping.
[SwitchB] mld-snooping
[SwitchB-mld-snooping] quit
# Create VLAN 104, assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to this VLAN, and
enable MLD snooping in this VLAN.
[SwitchB] vlan 104
[SwitchB-vlan104] port gigabitethernet 1/0/1 to gigabitethernet 1/0/3
[SwitchB-vlan104] mld-snooping enable
[SwitchB-vlan104] quit
# Create a user profile profile2 and configure the user profile so that users can join or leave only one IPv6
multicast group, FF1E::101. Then, enable the user profile.
[SwitchB] acl ipv6 number 2001
[SwitchB-acl6-basic-2001] rule permit source ff1e::101 128
[SwitchB-acl6-basic-2001] quit
[SwitchB] user-profile profile2
[SwitchB-user-profile-profile2] mld-snooping access-policy 2001
[SwitchB-user-profile-profile2] quit
[SwitchB] user-profile profile2 enable
# Create a RADIUS scheme scheme2; set the service type for the RADIUS server to extended; specify the
IP addresses of the primary authentication/authorization server and accounting server as 3::1; set the
shared keys to 321123; specify that a username sent to the RADIUS server carry no domain name.
[SwitchB] radius scheme scheme2
[SwitchB-radius-scheme2] server-type extended
[SwitchB-radius-scheme2] primary authentication 3::1
[SwitchB-radius-scheme2] key authentication 321123
[SwitchB-radius-scheme2] primary accounting 3::1
[SwitchB-radius-scheme2] key accounting 321123
[SwitchB-radius-scheme2] user-name-format without-domain
[SwitchB-radius-scheme2] quit
# Create an ISP domain domain2; reference scheme2 for the authentication, authorization, and
accounting for LAN users; specify domain2 as the default ISP domain.
[SwitchB] domain domain2
[SwitchB-isp-domian2] authentication lan-access radius-scheme scheme2
[SwitchB-isp-domian2] authorization lan-access radius-scheme scheme2
[SwitchB-isp-domian2] accounting lan-access radius-scheme scheme2
[SwitchB-isp-domian2] quit
[SwitchB] domain default enable domain2
# Globally enable 802.1X and then enable it on GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3
respectively.