H3C Technologies H3C S10500 Series Switches - Manual (Page 173)

158
Task Remarks
Enabling auto-RP
approach
Configuring C-RP timers globally Optional
Configuring a C-BSR Required
Configuring a BIDIR-PIM domain border Optional
Configuring global C-BSR parameters Optional
Configuring C-BSR timers Optional
Configuring a BSR
Disabling BSM semantic fragmentation Optional
Enabling administrative scoping Optional
Configuring administrative scoping Optional Configuring an admin-scope zone
boundary
Configuring C-BSRs for each admin-scope zone
and the global-scope zone
Optional
Configuring PIM common features Optional
Configuration prerequisites
Before you configure BIDIR-PIM, complete the following tasks:
• Configure a unicast routing protocol so that all devices in the domain can reach each other.
• Determine the IP address of a static RP and the ACL that defines the range of the multicast groups
to be served by the static RP.
• Determine the C-RP priority and the ACL that defines the range of multicast groups to be served by
each C-RP.
• Determine the legal C-RP address range and the ACL that defines the range of multicast groups to
be served.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout.
• Determine the C-BSR priority.
• Determine the hash mask length.
• Determine the ACL defining the legal BSR address range.
• Determine the BS period.
• Determine the BS timeout.
Enabling PIM-SM
Because BIDIR-PIM is implemented on the basis of PIM-SM, you must enable PIM-SM before enabling
BIDIR-PIM. To deploy a BIDIR-PIM domain, enable PIM-SM on all non-border interfaces of the domain.
Enabling PIM-SM globally for the public network
Follow these steps to enable PIM-SM for the public network:
To do... Use the command... Remarks
Enter system view system-view —